Plastic mold processing injection molding customization

Plastic mold has developed from simple surface processing to all-round processing of surface and structural surface, from medium and low speed gear processing to high speed processing, and the development of processing automation control is very rapid. The clamping force shall be sufficient.
At present, many plastic molds made of exquisite plastic mold.
In order to better mold quality level, we must pay attention to these when making plastic molds. Next, I will share my experience in mold production and manufacturing with everyone.
One mold must be installed in four nights with side lock (straight cylinder lock.
If an edge lock cannot be installed, a finish lock or a cone lock must be installed.
The finish lock shall be installed horizontally.
The second line must be accurately positioned.
Accurate positioning methods include wave beads and standard row position clamps, which must actually be in accordance with the regulations of each new project.
The row position must have decorative strips and wear-resistant steel.
Decorative strip, stainless steel sheet of insufficient purity
The first stage: hollow fiber membrane: hollow fiber membrane to remove a variety of drinking water can be seen in the dust and residue.
Wear-resistant steel must be applied with wear-resistant high hardness, and oil tank must be added.
The 3. basic structure mold must be laid out with supporting heads, and both sides must be ground off. The small mold must be prestressed and the large mold must be prestressed-.
4. mold blank surface layer in the whole process of production and manufacturing, must pay attention to maintenance, to avoid corrosion, scratch.
Before the mold is packaged, the core mold must be sprayed with milky white or non-colored anti-rust oil. The surface of all molds must be cleaned and tidy, and then coated with salt-free butter.
5. mold can not have bevel, must be rounded to solve.
outside the very indicated area.
The diameter of the precise positioning ring must conform to the engineering drawing, and the method and position of the top rod connector must conform to the engineering drawing.
6. the mold blank guide post guide sleeve to process the exhaust pipe groove, China's import of mold CNC lathe will continue to rely on a short time.
Prevent contusion of the guide sleeve of the guide post.